This series of high-frequency power supplies, designed for continuous NDT inspection, are available in 125kV, 160kV, and 220kV models, each with a 5mA output. Compact and reliable, they connect to X-Ray tubes for superior imaging and better evaluation. Ideal for OEM applications.
| PARAMETER | SPECIFICATION | ||||||
|---|---|---|---|---|---|---|---|
| Input Voltage | 230V ±10% AC, 50Hz, single phase | ||||||
| No. of Output | 2 | ||||||
| Output Voltage 1 |
|
||||||
| Output Voltage 2 |
|
||||||
| Output Current | 0 to 5mA | ||||||
| HF Generator Frequency | 40kHz | ||||||
| Filament Voltage and Current | As per tube selection by OEM | ||||||
| Polarity | Positive and negative | ||||||
| Protections | Over voltage, over current, filament open fault, short-circuit, and arc | ||||||
| Line Regulation | <0.1% for 10% variation in input voltage | ||||||
| Load Regulation | <0.5% for 10% load variation (tube current) | ||||||
| Mode of Operation | Constant voltage-constant & current (X-ray anode current) | ||||||
| 0-10VDC Signals from PLC to Power Supply |
Output voltage control Output current control |
||||||
| 0-24V DC Signals from PLC to Power Supply | Selection of HV ON/OFF, small / large filament, rotor start / stop | ||||||
| 0-10VDC Signals from Power Supply PLC |
Output voltage readout Output current readout |
||||||
| Rotating Anode Circuit | Based on 24VDC signals from the PLC, control the rotor supply 160V for 0.8sec and 40V for running till the presence of the 24V DC | ||||||
| Topology | SMPS | ||||||
| Cable and Connectors | To be supplied by the OEM | ||||||
| HT Tank |
|
||||||
| Inverter | 19” Rack (440mm × 458mm × 142mm) |