This series of power supplies generate two independent outputs of same or opposite polarities in the same power supply both having single control OR independent controls depending on requirement. These are housed in 19″ racks to give a highly regulated output.
| PARAMETER | SPECIFICATION | |
|---|---|---|
| Input Voltage | 230V ±10% AC, 50Hz, single phase for >2kW 415V ±10% AC, 50Hz, single phase for <2kW | |
| Output Voltage Range* | 1kV DC to 100kV DC | |
| Output Power Range* | 50W to 5kW | |
| Number of outputs | 2 | |
| Polarity* | Positive & negative (two outputs will be available simultaneously) | |
| Line Regulation | Better than 0.1% for±10% variation in input voltage | |
| Load Regulation | Better than 0.5% for 0 to 100% load variation | |
| Ripple | Upto 0.1% rms at full rating | |
| Stability | <0.1%/hour after 1 hour warm-up | |
| Regulation Mode* | Constant Voltage – Constant Current | |
| Voltage & Current Control* | Local: By 10-turn potentiometers on the front panel Remote: 0 to 10V DC signals for voltage & current control; OR Control through computer interface | |
| Protections* | Against over voltage, over load, short-circuit, and arc | |
| Remote Interface (Analog) through pluggable connector | 10V DC reference 10V DC HV enable signal 0 to 10V DC signal for voltage & current control 0 to 10V DC signal for voltage & current monitoring | |
| Optional. Remote Interface (Digital) through D-Connector (External Ethernert/RS232 Microcontroller Module)# | HV ON/OFF Voltage & current setting Voltage & current monitoring | |
| Front Panel | Power ON/OFF Switch / MCB with indication HV ON/OFF switch with indication Polarity indication 3½ digit voltage and current meters 10-turn potentiometers for voltage and current control Constant voltage – constant current mode indication | |
| Back Panel |
| |
| Topology | High frequency resonant / PWM-controlled switch mode | |
| Switching Device | IGBT | |
| Cabinet | 19″ rack, powder coated |